Basic Safety Rules and Requirements for Smt Pick and Place Machines

SMT pick and place machine is a high-tech product, safe and correct operation is very important for both machines and people. The most basic thing to safely operate an SMT pick and place machine is that the operator should have the most accurate judgment, and the following basic safety rules and requirements for SMT pick and place machines should be followed:

SMT pick and place machine

1. The operator of the SMT pick and place machine should receive the operation training under the correct method.

2. Check the pick and place machine, turn off the power when replacing parts or repairing and internal adjustments (the maintenance of the machine must be carried out when the emergency button is pressed or the power is turned off.

3. Make sure that "reading coordinates" and adjusting the pick and place machine (programming components) are in your hands to stop the action at any time.

4. Make sure that the "interlock" safety equipment remains effective to stop the machine at any time, and the safety detection on the machine cannot be skipped or short-circuited, otherwise personal or machine safety accidents will easily occur.

5. Only one operator is allowed to operate one machine during production.

6. During operation, make sure that all parts of the body, such as hands and head, are out of the range of movement of the machine.

7. SMT equipment must be properly grounded (real grounded, not connected to the neutral line).

8. Do not use the machine in a gas or extremely dirty environment.

9.Matters needing attention:

①Those who have not received training are strictly prohibited from operating the machine.

②Safety first, the machine operator should operate the machine strictly according to the operating specifications, otherwise it may cause damage to the machine or endanger personal safety.

③The pick and place machine operator should be careful and attentive.