1. Please place the machine close to the place that meets the power supply of this equipment, and the ground should be stable.
2. Make sure that the power switch is off, and then plug in the power cable.
3. Open the door lock and lift the top cover of the machine.
4. Place the solder paste can
4.1 Please take out the solder paste that needs to be stirred, remove the inner cover of the solder paste, and tighten the cover again.
4.2 If it is necessary to stir two tins of solder paste at the same time each time, the masses should be equal, and the difference should be within 50 grams.
4.3 If only one tin of solder paste is stirred at a time, please load the waste solder paste of the same specification and quality into another fixture to keep it in balance. (Note that the old cans are marked to avoid mixing).
4.4 Open the solder paste jig, put the solder paste can into it, then close the lid, and lock the lid buckle.
If the solder paste tank is not standard equipment, too large or too small, please contact our company.
4.5 After loading the solder paste, make sure that nothing is left in the machine.
5. Close the cover and lock the door lock.
6 Turn on the power switch, if you need to adjust the time, please set the time relay.
7 According to the bright switch, the lighting lights are turned on. If you want to start the machine, you must reset the lighting switch; press the start switch, the machine starts to run, and the lights are also on. When the set time is reached, the motor stops running, and the colored lights are also extinguished at the same time. When the motor is running, press the stop switch, the motor will stop running, and the colored lights will go out at the same time.
8 When the machine is running, if you want to forcibly turn off the power and open the upper cover, be careful not to touch the rotating parts.
1.User manual 1 pcs
2.Machine body 1 set
3.2 rubber pads (used to keep the locking screw of the solder paste fixture clean)
4.Power cord 1 pcs