0.5MPa High Precision SMT Placement Machine With 7inch Touch Screen
AC220V (50Hz, single phase) /AC110V (60Hz, single phase);
|Vacuum Generation||Built-in vacuum pump|
|Mounting Head Quantity||4|
8000cph(optimalwithout vision detection);
|PCB Conveying||Manual operation|
|Nozzle Change||Manual operation|
Built-in computer (embedded Linux operating system),
|Drive System||X&Y-axisdriven by stepping motors in the way of closed-loop control; Z-axis capable of reset detection;all motors adopting flexible S-curve acceleration and deceleration|
|Transmission System||Synchronous belt + linear guide|
30 Yamaha standard pneumatic feeder stacks
|Vision System||Up-looking camara for component automatic calibration (component size applicable: 22mm×22mm); down-looking camera for PCB calibration via Mark Point and component positioning|
Vision System Ensure Accuracy
Auto correction offset
The double CCD vision cameras can auto calibrate the offset for all different kinds of components and ICs(auto correction of pick position and angle). Industry camera with high accuracy taking image of pins if IC, to ensure the patch accuracy.
30pcs Yamaha pneumatic feeder supported
simple & convenient operation
CHM-T530P4 work with standard Yamaha pneumatic feeder ,it is more stable and longer lifetime. pneumatic feeders can improve the working efficient a lot. It can also work with Yamaha vibration feeder.
Closed-loop Motion Control System
it can be four-axis linkage, move faster and smoothly. both nozzle can working together, not single nozzle working any more, support single step. X,Y axis encoder installed, never lose step. Flexible S accelerate and decelerate, make sure high speed placement working perfectly.
Z Axis Detection
Z axis detection function can self-checking the height and angle during placement.
Make sure machine work perfectly with different kinds of components.
9 kinds of Juki nozzles supported, magnet inside, you can change the nozzle by hand, no need wrench, very convenient.
Industry Touch Screen
Machine uses embedded Linux operation system, This system runs stable with strong compatibility and powerful function. Machine has a in-build 7 inch full touch screen, external USB mouse also accepted. Very easy and convenient operation. You can get a quick start within half an hour.
Mark point auto calibration
more accurate with vision system
After PCB has been put on machine, the machine will use the camera to automatically find the mark point, calibrate the PCB and avoid deviation.
Front IC Bulk Material Area
11pcs front bulk IC stack, suitable for some bulk ICs. more convenient.
IC Tray Supported
software allow 20 user-defined IC tray
User can add one or more IC tray in software, you just need to positioning the first component and the last component, then machine can auto continuous picking.
1. Whether the linear guide rail and round rod have an impact on the accuracy of the SMT pick and place machine ?
No impact at all .Using linear guide rail or round rod has no effect on the accuracy of the mounting machine, the precision of the mounting machine depends on the motor and software control system used by the mounting machine only.
2. Is the software control system of your desktop SMT independently developed by your company?
Yes, our desktop SMT uses Linux system. Linux system supports cross-platform hardware support, rich software support, reliable security and stability.
3. Do you use electromagnetic coil to control the pulling needles? What are the advantages if comparing to cylinder control?
Yes, the drawing needle we use is controlled by the electromagnetic coil. Comparing with the cylinder control, the electromagnetic coil control has the characteristics of faster response, softer force and less noise. The quick reaction can speed up the mounting speed; Soft strength refers to the strength of the pull needle is soft when pressing down, and the pull needle is not easy to break.
Hunan Charmhigh Electromechanical Equipment Co., Ltd
Contact Us at Any Time