SMT Production line: CHM-T48VA Pick and Place Machine + High Precision 3040 Stencil Printer + CHMRO-420 Reflow Oven, PC
AC220V (50Hz, single phase) /AC110V (60Hz, single phase);
|Air Supply||No external air supply required|
|Vacuum Generation||Built-in vacuum pump|
|Mounting Head Quantity||2|
6000cph(optimalwithout vision detection);
4000cph (optimal with vision detection)
|PCB Conveying||Manual operation|
|Nozzle Change||Manual operation|
Built-in computer (embedded Linux operating system),
7-inch touch screen
|Drive System||X&Y-axis driven by stepping motors in the way of closed-loop control realized by encoder; Z-axis capable of reset detection;all motors adopting flexible S-curve acceleration and deceleration; tape puller automatic reset supported|
|Transmission System||Synchronous belt+polished rod|
|Feeding System||29 tape feeding stacks(8mm:22,12mm:4,16mm:2,24mm:1；customization supported), 14 preset general IC stacks, worksurface custom IC trays and stick feedersupported|
|Vision System||Up-looking camara for component automatic calibration (component size applicable: 22mm×22mm); down-looking camera for PCB calibration via Mark Point and component positioning|
The new vision system CHMT48VA is independent product of Charmhigh, updated from CHMT48V Model, with advanced technology in China, special for research Lab, medium enterprise, small factories, Electronics enthusiasts or enterpreneur etc. It is small with high precision, accurate positioning, easy operation with stable performance. It is the best small desktop PNP machine in China, Now leading the technology in China.
here are some highlights as follows:
1. Whether the linear guide rail and round rod have an impact on the accuracy of the SMT pick and place machine ?
No impact at all .Using linear guide rail or round rod has no effect on the accuracy of the mounting machine, the precision of the mounting machine depends on the motor and software control system used by the mounting machine only.
2. Is the software control system of your desktop SMT independently developed by your company?
Yes, our desktop SMT uses Linux system. Linux system supports cross-platform hardware support, rich software support, reliable security and stability.
3. Do you use electromagnetic coil to control the pulling needles? What are the advantages if comparing to cylinder control?
Yes, the drawing needle we use is controlled by the electromagnetic coil. Comparing with the cylinder control, the electromagnetic coil control has the characteristics of faster response, softer force and less noise. The quick reaction can speed up the mounting speed; Soft strength refers to the strength of the pull needle is soft when pressing down, and the pull needle is not easy to break.
Contact Us at Any Time