Charmhigh small pick and place machine English Version CHM-T560P4
AC220V (50Hz, single phase) /AC110V (60Hz, single phase);
|Air Supply||0.5MPa ~0.7MPa|
|Vacuum Generation||Built-in vacuum pump|
|Mounting Head Quantity||4|
8000cph(optimalwithout vision detection);
5500cph (optimal with vision detection)
|PCB Conveying||Manual operation|
|Nozzle Change||Manual operation|
Built-in computer (embedded Linux operating system),
7-inch touch screen
|Drive System||X&Y-axisdriven by stepping motors in the way of closed-loop control; Z-axis capable of reset detection;all motors adopting flexible S-curve acceleration and deceleration|
|Transmission System||Synchronous belt + linear guide|
60 Yamaha 8mm standard pneumatic feeder stacks
(also suitable for Yamaha electric feeder, IC tray, and stick feeder), 11 preset general IC stacks, worksurface custom IC trays supported
|Vision System||Up-looking camara for component automatic calibration (component size applicable: 22mm×22mm); down-looking camera for PCB calibration via Mark Point and component positioning|
Vision System Ensure Accuracy
Auto correction offset
The double CCD vision cameras can auto calibrate the offset for all different kinds of components and ICs(auto correction of pick position and angle). Industry camera with high accuracy taking image of pins if IC, to ensure the patch accuracy.
60pcs Yamaha pneumatic feeder supported
simple & convenient operation
CHM-T560P4 work with standard Yamaha pneumatic feeder ,it is more stable and longer lifetime. pneumatic feeders can improve the working efficient a lot. It can also work with Yamaha vibration feeder.
Z Axis Detection
Z axis detection function can self-checking the height and angle during placement.
Make sure machine work perfectly with different kinds of components.
9 kinds of Juki nozzles supported, magnet inside, you can change the nozzle by hand, no need wrench, very convenient.
Closed-loop Motion Control System
it can be four-axis linkage, move faster and smoothly. both nozzle can working together, not single nozzle working any more, support single step. X,Y axis encoder installed, never lose step. Flexible S accelerate and decelerate, make sure high speed placement working perfectly.
Industry Touch Screen
Machine uses embedded Linux operation system, This system runs stable with strong compatibility and powerful function. Machine has a in-build 7 inch full touch screen, external USB mouse also accepted. Very easy and convenient operation. You can get a quick start within half an hour.
Mark point auto calibration
more accurate with vision system
After PCB has been put on machine, the machine will use the camera to automatically find the mark point, calibrate the PCB and avoid deviation.
Front IC Bulk Material Area
11pcs front bulk IC stack, suitable for some bulk ICs. more convenient.
IC Tray Supported
software allow 20 user-defined IC tray
User can add one or more IC tray in software, you just need to positioning the first component and the last component, then machine can auto continuous picking.
Hunan Charmhigh Electromechanical Equipment Co., Ltd
Contact Us at Any Time